江苏安科瑞电器制造有限公司的工程案例详情
发布日期：2021-09-14 点击量：156
安科瑞 陈聪 周洁
摘要：随着电力工业的发展，对设备的安全性、可靠性要求越来越高。在这种条件下，高压设备的无线测温系统应运而生。这种技术是将内置电池或电流感应和无线发射模块的测温传感器安装于各测温点，由于其体积小，且无需任何接线，其电气安全性可以得到保证。传感器周期性的将测温数据无线发送至接收单元，接收单元可联网将数据送至主站，以此实现一个区域系统的电气温度监测。
本文介绍了无线测温传感器在荷兰某变配电室的应用
Abstract: With the development power industry,the requirements for the safety and reliability of equipment are getting higher and higher. In this situation,ACREL wireless temperature monitoring system is designed for high voltage device. This technology is to install the temperature sensor with built-in battery or temperature sensor by current sensing and wireless transmitter module at each temperature measurement point. The sensor periodically sends the temperature measurement data wireless to the receiving unit, and the receiving unit can be connected to the network to send the data to the master station, thereby realizing electrical temperature monitoring of a regional system.
This article introduce wireless monitoring system used in substations in Netherlands.
1.当前现状 Current Status
多年来，由于技术水平的限制，虽然曾利用红外测温仪、红外成像仪、感温电缆、传统的点式测温系统希望解决上述问题，但都无法实现开关柜内如断路器、刀闸联接点和触头测温。目前，国内电力测温主要应用红外点测仪和光纤测温仪，而在线方式由于无法解决高压绝缘问题，所以高压开关的触点等空间有限的电气设备基本上都是处于完全无监控的状态下运行，存在重大安全隐患。
For many years, due to the limitations of the technical level, although infrared thermometer, infrared imager, temperature sensing cable, traditional point-type temperature measurement system have been used to solve the above problems, but can not achieve the switch cabinet such as circuit breaker, the connection point and contact temperature measurement. At present, domestic electric temperature measurement mainly uses infrared point measuring instrument and optical fiber temperature measuring instrument. However, the on-line bbbbbb cannot solve the problem of high-voltage insulation, so the electrical equipment with limited space, such as the contact of high-voltage switch, basically operates in a completely unmonitored state, with major safety hazards.
2.项目概述 Project Overview
荷兰DigIoT公司是一家电力物联网公司，为当地各变电站提供电力物联网服务。客户咨询安科瑞无线测温产品，希望通过安科瑞ATE无线温度传感器和ATC接收器，对开关柜内的线缆进行温度检测，并通过RS485通讯将数据传输到后台进行实时监控，从而可以有效预防开关柜内部过热发生故障，影响设备正常运转，避免安全隐患。
DigIoT is an electric IoT company, providing electrical IoT services for local substations. Customer consults Acrel wireless temperature measurement products, attending through Acrel ATE wireless temperature sensor and ATC receiver, the cable in the switchgear temperature detection, And through RS485 communication data transmission to the back platbbbb for real-time monitoring, can effectively prevent overheating failure, affect the normal operation of equipment, avoid safety risks.
3.无线测温产品介绍
Wireless temperature monitoring device Introduction
安科瑞在线测温装置适用于高低压开关内线缆街头，断路器触头，高压线缆中间头，低压大电流等设备的温度检测，防止在运行过程中因氧化，松动等因素造成接点接触电阻过大而发热成为安全隐患，及时，持续及准确反映设备运行状态，提供设备安全性。
Acrel on-line temperature measurement device is suitable for the temperature detection of high and low voltage switches, circuit breaker contacts, high voltage cable middle heads, low voltage and high current equipment, to prevent contact caused by oxidation, loosening and other factors during operation Excessive contact resistance and heat generation become a safety hazard, timely, continuous and accurate reflection of equipment operating status, and equipment safety.
3.1 无线测温方案Wireless temperature measurement scheme
安装于发热部位，采集温度量并通过无线方式传输的传感器。
目前无线温度传感器有四款：
sensor installed in a heating area that collects temperature and transmits it wirelessly.
There are currently four type wireless temperature sensors:
|
名称 |
外形 |
参数说明 |
安装方式 |
|
ATE100M |
|
32.4*32.4*16mm(长*宽*高)；-50℃~+125℃，精度±1℃，电池供电，寿命≥5年；470MHz，空旷距离150米。 |
磁吸固定 |
|
ATE100 |
|
62.4*32.4*16mm，φ13.5mm(长*宽*高，孔径)；-50℃~+125℃，精度±1℃，电池供电，寿命≥5年；470MHz，空旷距离150米。 |
螺栓固定 |
|
ATE200 |
|
35*35*17mm，L=330mm(长*宽*高，表带)；-50℃~+125℃，精度±1℃，电池供电，寿命≥5年；470MHz，空旷距离150米。 |
表带捆绑 |
|
ATE100P |
|
62.4*32.4*16mm，φ13.5mm(长*宽*高，孔径)；-50℃~+150℃，精度±0.5℃，电池供电，寿命≥5年；470MHz，空旷距离150米；防护等级IP68。 |
户外螺栓固定 |
|
ATE200P |
|
35*35*17mm，L=330mm(长*宽*高，表带)；-50℃~+150℃，精度±0.5℃，电池供电，寿命≥5年；470MHz，空旷距离150米；防护等级IP68。 |
户外表带捆绑 |
b. CT感应取电无线温度传感器CT induction radio wireless temperature sensor
安装于断路器触头、母排、电缆搭接点等大电流处，采集温度量并通过无线方式传输的传感器。
目前无线温度传感器有两款：
sensor installed at a high current such as a circuit breaker contact, a bus bar, a cable lap contact, to collect temperature and transmit it wirelessly.
There are currently two wireless temperature sensors:
|
名称 |
外形 |
参数说明 |
安装方式 |
|
ATE300 |
|
73*33.5*16mm(长*宽*高)；CT感应取 电，启动电流≥5A；470MHz，空旷距 离150米。 |
扎带固定 合金片取电
|
|
ATE400 |
|
25.82*20.42*12.8mm(长*宽*高)；-50℃~+125℃，精度±1℃，CT感应取电，启动电流≥5A；470MHz，空旷距离150米。 |
合金片固定、 取电 |
|
名称 |
外形 |
参数说明 |
安装方式 |
|
ATC450-C |
|
65*45*28mm(长*宽*高)；DC24V供电；一路上行RS485接口，可接收60个ATE100/ATE100M/ATE200/ATE400/ATE100P/ATE200P无线温度传感器温度；Modbus协议。 |
35mm导轨安装 螺丝固定 (φ4,36mm) |
|
ATC600 |
|
90*90*38mm(长*宽*高)；AC/DC 85～265V 供电；一路上行RS485接口,可接收240个ATE100/ATE100M/ATE200/ATE400/ATE100P/ATE200P无线温度传感器温度； Modbus协议。 |
35mm导轨安装
|
b. 显示单元Displaying Unit
|
名称 |
外形 |
参数说明 |
安装方式 |
|
|
ARTM-Pn |
|
面框96*96*17mm，深度65mm，开孔92*92mm，AC85-265V或DC100-300V供电；一路上行RS485接口；可接收60个ATE100M/100/200/400/ATE100P/ATE200P无线温度传感器(配套ATC450)；Modbus协议。 |
面板开孔嵌入式安装 |
|
|
ASD300/320 |
|
面框237.5*177.5*15.3mm，深度67mm，开孔220*165mm；AC85-265V或DC100-300V供电；一路上行RS485接口；可接收12个ATE100M/100/200/400无线温度传感器温度(配套ATC450)；Modbus协议。 |
面板开孔嵌入式安装 |
|
|
ATP007 |
|
面框226.5*163*6mm，深度70mm；开孔215*152mm；DC24V供电；一路上行RS485接口，一路下行RS485接口；可接收4个ATC450-C或者1个ATC600。 |
面板开孔嵌入式安装 |
|
|
ARTM-8 |
|
面框96*96*12.5mm，深度70mm，开孔88*88mm；一路上行RS485接口，可接8路Pt100温度传感器； Modbus协议
|
面板开孔嵌入式安装 |
|
|
Acrel-2000T/A |
|
柜体尺寸480*420*200mm；DC220V供电；一路上行RS485接口，一路下行RS485接口，一路以太网口；可接收4个ATC450-C或者1个ATC600。 |
壁挂式安装 |
|
|
Acrel-2000T/B |
|
柜体尺寸为480*420*200mm；硬件：内存4G，硬盘128G，以太网口；显示器：12寸，分辨率800*600；操作系统：bbbbbbs 7；数据库系统： Microsoft SQL Server 2008 R2； I/O接口：GLAN×2、USB×4、COM×6； 可选Web平台/APP服务器 |
壁挂式安装 |
|
3.2结构图 Structure
3.3 产品方案组合图 Typical Solution
4.典型应用Typical Application
参考文献 Bibliography
1、Solutions for enterprise micro-grid system
江苏安科瑞电器制造有限公司
联系人：陈聪 周洁
电话：18860995110
地址：江苏省江阴市南闸街道东盟路5号
