产品详情
停车场、地下车库施工完环氧地坪后，都需要将道路、车位和指示箭头用黄色的涂料标示出来，而且为了道路线和指示箭头的耐用，以及对地面线路反光性能的要求，一般使用热熔涂料画线。<\/span> <\/p> <\/span>热熔标线涂料属于熔融型涂，当温度达到180—220℃<\/span>时，涂料就变成粘稠的流动状态，常温下就变成固态。在把热熔涂料涂敷于路面的同时撒上玻璃珠，就可以让热熔涂料标示的道路线具有反光性能，在停电的情况下，只要车头灯照射依旧明显可见。提高地下车库下行车的安全性。<\/span><\/span> <\/p> <\/span><\/span><\/span> <\/p> 使用注意事项：<\/span><\/span> <\/p> <\/span><\/span>一、<\/span> <\/span><\/span>储存<\/span><\/span> <\/p> 1<\/span><\/span>、叠放层次不宜过高，一般以八层为宜<\/span>;<\/span><\/span><\/span> <\/p> 2<\/span><\/span>、存放时间不宜过长，一般以三个月内使用**，超过半年品质将受影响（如颜色变黄，软化点升高，材质塑性下降等）。<\/span><\/span> <\/p> <\/span><\/span>二、<\/span> <\/span><\/span>煮料<\/span><\/span> <\/p> 1<\/span><\/span>、<\/span> <\/span><\/span>严格控制好煮料温度，一般在<\/span>180<\/span><\/span>°<\/span>C-220<\/span><\/span>°<\/span>C,<\/span><\/span>严禁超过<\/span>220<\/span><\/span>°<\/span>C<\/span><\/span>；<\/span><\/span> <\/p> 2<\/span><\/span>、注意热熔釜的搅拌功能，一定要充分搅拌才能出料；<\/span><\/span> <\/p> 3<\/span><\/span>、严禁不同厂家和不同颜色的涂料混合使用。<\/span><\/span> <\/p> 三、<\/span> <\/span><\/span>路面状况<\/span><\/span> <\/p> 1<\/span><\/span>、<\/span> <\/span><\/span>路面必须清洁干净，无旧线、油污和其他污垢物，同时保持干燥无湿度；<\/span><\/span> <\/p> 2<\/span><\/span>、路面温度应高于<\/span>10<\/span><\/span>°<\/span>C<\/span><\/span>以上方可施工；<\/span><\/span> <\/p> 3<\/span><\/span>、除新沥青路面，其他路面必须涂布底漆；<\/span><\/span> <\/p> 4<\/span><\/span>、<\/span> <\/span><\/span>新的水泥路面一定要使用三个月以上才可施工。<\/span><\/span> <\/p> <\/span><\/span>四、<\/span> <\/span><\/span>施工过程<\/span><\/span> <\/p> 1<\/span><\/span>、注意检验涂料、底漆和路面之间的粘结力，每个工作日**取三次试样；<\/span><\/span> <\/p> 2<\/span><\/span>、注意反光玻璃珠的附着情况和反光效果，适时调整涂料的温度；<\/span><\/span> <\/p> 3<\/span><\/span>、注意标线的颜色效果，若有白色变黄，黄色变绿的现象，应立即降低热熔釜温度，直到恢复正常。<\/span><\/span> <\/p> <\/span><\/span> <\/p> 五、<\/span> <\/span><\/span>涂料用量<\/span><\/span> <\/p> 1<\/span><\/span>、水泥路面，涂膜厚度<\/span>1.8mm,<\/span><\/span>每平方用料<\/span>5<\/span><\/span>公斤左右；<\/span><\/span> <\/p> 2<\/span><\/span>、<\/span> <\/span><\/span>沥青路面，涂膜厚度<\/span>1.8mm,<\/span><\/span>每平方用料<\/span>5.5<\/span><\/span>公斤左右；<\/span><\/span> <\/p> 3<\/span><\/span>、每平方玻璃珠用量<\/span>0.25<\/span><\/span>公斤左右；<\/span><\/span> <\/p> 4<\/span><\/span>、每平方底漆用量<\/span>0.2<\/span><\/span>公斤左右。<\/span><\/span> <\/p> <\/span><\/span>六、<\/span> <\/span><\/span>标线的完好率<\/span><\/span> <\/p> 1<\/span><\/span>、<\/span> <\/span><\/span>标线刚施工完验收时，完好率应达<\/span>99%<\/span><\/span>以上；<\/span><\/span> <\/p> 2<\/span><\/span>、标线使用半年内，完好率应保持<\/span>90%<\/span><\/span>以上；<\/span><\/span> <\/p> 3<\/span><\/span>、标线使用一年以内，完好率应保持<\/span>75%<\/span><\/span>以上；<\/span><\/span> <\/p> <\/span><\/span>停车场：热熔标线<\/span>,<\/span><\/span>反光标线<\/span>,<\/span><\/span>振荡标线<\/span>,<\/span><\/span>车位线<\/span>,<\/span><\/span>划线<\/span>,<\/span><\/span>斑马线<\/span>,<\/span><\/span>停车线<\/span>,<\/span><\/span>热熔线<\/span>,<\/span><\/span>